International Journal of Scientific Research and Engineering Development

International Journal of Scientific Research and Engineering Development


( International Peer Reviewed Open Access Journal ) ISSN [ Online ] : 2581 - 7175
Submit Your Manuscript OnlineIJSRED

Aerodynamic Modelling, Stability Assessment and Low-Cost Fabrication Planning of a NACA 2412 Fixed-Wing UAV Glider Using XFLR5


📑 Paper Information
📑 Paper Title Aerodynamic Modelling, Stability Assessment and Low-Cost Fabrication Planning of a NACA 2412 Fixed-Wing UAV Glider Using XFLR5
👤 Authors Kolasani Karthikeya, Jonnala Saicharan, Irfan, Karan Kumar
📘 Published Issue Volume 9 Issue 6
📅 Year of Publication 2026
🆔 Unique Identification Number IJSRED-V9I6P35
🌐 DOI 10.5281/zenodo.24194515
📝 Abstract
Small unmanned aerial vehicles (UAVs) operate at low Reynolds numbers, where the choice of airfoil, the wing loading and the sizing of the tail surfaces govern both stability and stall behaviour. Evaluating these influences on a computer before any material is cut reduces waste, effort and expense. This paper describes the aerodynamic design and analysis of an inexpensive, hand-launched fixed-wing glider UAV intended for a cruise speed of 10 m/s. The airframe combines a NACA 2412 airfoil, a tapered wing with a 2.0 m span (root chord 0.180 m, tip chord 0.110 m, planform area 0.290 m2, aspect ratio 13.79), a conventional elevator and a fin. The section was studied in XFoil, and the complete aircraft in XFLR5 v6.62 with the vortex lattice method (VLM1) over angles of attack from −5° to 15°. Analytical calculations based on an assumed mass of 0.45 kg give a wing loading of 15.2 N/m2, a stall speed between 4.2 and 4.5 m/s, a mean aerodynamic chord of 0.148 m and a cruise Reynolds number near 100,000. The pitching-moment slope is negative, which indicates static stability in pitch, and the spanwise lift distribution is dome-shaped and close to elliptical. The horizontal tail volume coefficient (0.49) lies within the recommended band, whereas the vertical tail volume coefficient (0.013) falls short of the target, so an enlargement of the fin by about 50 % is proposed. Because the analysis is inviscid, drag-related values are indicative only. A low-cost foamboard construction procedure, a centre-of-gravity (CG) balancing method and a flight-test plan are also documented; building and flight-test validation remain pending.
📝 How to Cite
Kolasani Karthikeya, Jonnala Saicharan, Irfan, Karan Kumar, "Aerodynamic Modelling, Stability Assessment and Low-Cost Fabrication Planning of a NACA 2412 Fixed-Wing UAV Glider Using XFLR5" International Journal of Scientific Research and Engineering Development, V9(6): Page(243-251) November - December 2026. ISSN: 2581-7175. www.ijsred.com. Published by Scientific and Academic Research Publishing.